Swiftech MCW60-T VGA Thermoelectric Waterblock
Author: OCIA Staff
Editor: Shawn Knight
Date: 08-01-2006
Provided by: Swiftech
Pages:
Installation



Now the backplate is installed and firmly pressed to the back of the card.



The next step is to remove the wax paper from the board gasket.



Then press the board gasket down in place evenly and firmly.



After applying some ceramique thermal compound, we slide the block over the threaded bolts.



Now it's time to grab the thumb-nuts, springs, and screw insulators.



We thread the thumb-nuts evenly and gradually until we feel the screw insulator keeping the thumb-nut from going any further. Swiftech stresses not to over tighten these thumb-nuts.



This is just a quick shot of the ramsink I will be using in conjunction with the MCW60-T during testing.

Now let's continue to the next page and wire this baby up!


  Sponsors Links

  Sponsors Links